I tried it with the HELI-X6 simulator and it didn’t work either. I later got it to work but not sure why it didn’t work at first, it was perhaps because I had the switch on my dongle in the wrong position (Phoenix RC mode doesn’t work). I couldn’t find any mac drivers despite lots of searching so I haven’t used any dongle specific drivers.įirstly I tried to use the controller with the Freerider simulator, but it didn’t work at this point. The software linked to by Banggood are Windows drivers and are useless for Mac. Then it will either: stay on constantly if it hasn’t found your transmitter, or it will blink slowly if you’ve connected your transmitter to it with the cable and it has detected it without any problem. When you connect it to your USB it will flash rapidly for a few seconds. I bought this one from Bangood, I think they all work the same though: įor this dongle at least, there is a white LED inside. I quickly realized it was necessary to buy a cheap USB dongle to act as an interface or USB “controller” to translate the PPM signal from my transmitter into something that Mac OSX could understand. I hope this thread will help others to use their controller with their mac and flight simulators without expensive or difficult to use additional software. The only answer I could find was using a VM but after about a week I got it to work. Hi, this is my first post on RC Groups, I had a lot of trouble trying to get my transmitter to control quad flight sims on my mac using OSX and without using a VM (virtual machine) because my mac doesn’t have any VM software installed or set up.
0 kommentar(er)
